ps2 modem

ps2 modem

How to Install

1. An official Sony PS2 network adapter, as shown below. Either type (Ethernet only, Ethernet and Modem) can be used.

2. A suitable hard disk drive. You have two options here - the official Sony hard disk drive, or a standard IDE hard disk drive with a capacity of AT LEAST 40GB. If you use a standard IDE drive, you will need to make sure that it actually fits into your network adapter. There are a few known compatibility issues with some non-Sony hard disk drives, please see the compatibility section for more information. Both a Sony and standard IDE hard disk drive are shown below.

3. A PS2 with a "DEV9" expansion port. All PS2's will have this expansion port except for the first three Japanese models (SCPH 10000, SCPH 15000 and SCPH 18000) which have a PCMCIA expansion port instead. These models are not supported by HDLoader.

If you have an official Sony hard disk drive, then please install it according to the directions in its manual. If you will be using a standard IDE hard disk drive, then please install it according to the following directions.



The first step is to make sure that the hard disk drive you intend to connect to your PS2 will actually fit into your network adapter. Check that the IDE and power ports on your hard disk drive properly align with the IDE and power connectors on your network adapter, as shown below.

Configure the jumper setting on the hard disk drive so it is set to MASTER. To find the correct jumper settings for your hard disk drive, either check the label on top of the hard disk drive or consult your reference manual.




Attach the hard disk drive to the network adapter by lining up the IDE and power ports/connectors and pressing firmly, as shown below.

Carefully slide the hard disk drive into the PS2 expansion bay as shown below.

Push until the network adapter is connected to the back of your PS2, then screw in the screws on the back of the network adapter to secure the hard disk drive and network adapter in place as shown below.

Congratulations, you have successfully connected a hard disk drive to your PS2




Once you are up and going, the HDLoader screens look something like this: